REX Flaring Tools & Kits

RX-275 LM flaring kit

RX-275 LM REX Flaring Tool Kit

TECHNICAL SPECIFICATION
PART NO. SPECIFICATION
RX-275 LM For 1/8”, 3/16”, 1/4”, 5/16”, 3/8”, 7/16”, 1/2″, 5/8” & 3/4” O.D Tubing.

Includes – 5 swage adapters which cover 3/16”,  1/4”, 3/8”, 1/2”, 5/8”, 3/4”

RX-278 LM Flaring Kit

RX-278 LM REX Flaring Tool Kit

TECHNICAL SPECIFICATION
PART NO. SPECIFICATION
RX-278 LM For 1/8”, 3/16”, 1/4”, 5/16”, 3/8”, 7/16”, 1/2″, 5/8” & 3/4” O.D Tubing.

Includes – 5 swage adapters which cover 3/16”,  1/4”, 3/8”, 1/2”, 5/8”, 3/4” along with Tube Cutter & Ratchet Spanner.

REX Flaring Tool 525 – AM

  • Insert tubing into adjustable opening of tube holding assembly. Position end of tubing approximately 1/8″ above the surface of holder.
  • Tighten clamp screw approximately 1/2″ to 3/4″ of a turn beyond free travel position to secure tubing.
  • Be certain flaring cone surface is oiled. Slip yoke over tube holding assembly center on tubing. Twist yoke clockwise to lock in position. Turn yoke handle clockwise to flare.
  • For 3/16″ to 5/8″ & 5mm to 16mm O.D.

REX Flaring Tool RX – 195 

This rex flaring tool can be used for the following sizes –

3/16″, 1/4″, 5/16″, 3/8″, 7/16″, 1/2″, 5/8″